40255 Media Handler MDH: The <Stepper> stepper motor is losing steps (<Distance> mm) Magnus_VLF Upon homing the given stepper, the position was not within a reasonable amount of what it should have been. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Stepper hardware failure Stepper interference Stepper - This is the name of the stepper. Distance - This is the distance that the lost steps covered. 15-Nov-2003 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:23 2008 PST